Intel Quark SoC X1000 Software User's Manual page 22

111 #
listed below.
112 # (2) If you wish to build an image (Linux kernel, grub and
root file-system) that
113 #
devkit-multilibc
114 #DISTRO ?= "iot-devkit-spi"
115 DISTRO ?= "iot-devkit-multilibc"
After:
102 # Default policy config
103 #
104 # The distribution setting controls which policy settings are
used as defaults.
105 # The default value is fine for general Yocto project use, at
least initially.
106 # Ultimately when creating custom policy, people will likely
end up subclassing
107 # these defaults.
108 #
109 # Notes:
110 # (1) If you wish to build an image for the Galileo's on-
board SPI flash you
111 #
listed below.
112 # (2) If you wish to build an image (Linux kernel, grub and
root file-system) that
113 #
devkit-multilibc
Intel® Quark™ SoC X1000 Board Support Package (BSP)
Build and Software User Guide
22
need to set DISTRO to one of the iot-devkit-spi value
is stored on SD card, you need to set DISTRO to iot-
need to set DISTRO to one of the iot-devkit-spi value
is stored on SD card, you need to set DISTRO to iot-
Document Number: 329687-011US
May 2017