Building All The Edkii Firmware Validated Build Configurations [Linux Build Environment Only] - Intel Quark SoC X1000 Software User's Manual

The svn update command can take a few minutes to complete depending on the speed
Note:
of your internet connection.
If these commands fail, it may be due to your proxy settings. Contact your network
Note:
administrator. You may find answers about proxy settings here:
https://wiki.yoctoproject.org/wiki/Working_Behind_a_Network_Proxy
The examples above do not show the optional OpenSSL pre build step described in the
Note:
CryptoPkg/Library/OpensslLib/Patch-HOWTO.txt file.
4.3 Building all the EDKII Firmware Validated Build
Configurations [Linux build environment only]
This section is only supported in Linux Build environments. The
buildallconfigs.sh file is used to build all the validated EDKII build configurations.
Open a terminal window and cd to the Quark_EDKII* directory created in
"Performing pre-build Steps in a Linux/gcc Build
The script has the following options:
buildallconfigs.sh [GCC44 | GCC45 | GCC46 | GCC47 | GCC48 | GCC49] [GCC Path]
[PlatformName]
 GCC4x
GCC flags used for this build. Set to the version of GCC you have installed.
Note: Tested on GCC46. GCC43 is not supported from release 1.2 onwards.
 GCC Path
Location where the GCC is installed. GCC Path is not needed for release 1.1 and
earlier.
 [PlatformName]
Name of the platform package you want to build.
Example usage:
Create a build for an Intel® Quark™ SoC platform based on GCC version 4.6: For release
1.2 onwards:
./buildallconfigs.sh GCC46 /usr/bin/ QuarkPlatform
For release 1.1 and earlier:
./buildallconfigs.sh GCC46 QuarkPlatform
Intel® Quark™ SoC X1000 Board Support Package (BSP)
Build and Software User Guide
12
Environment".
Document Number: 329687-011US
Section 4.2.1,
May 2017