Programming Flash Using Uefi Shell - Intel Quark SoC X1000 Software User's Manual

Board support package (bsp)

Hide thumbs Also See for Quark SoC X1000:

Table of Contents

Firmware downgrade from release 1.2.1 to an older release does not require any

Note:

special steps, only the upgrade process requires additional attention.

10.2

Programming flash using UEFI shell

This procedure cannot be used for a secure SKU board (Industrial/Energy or

Transportation Reference Design) because the UEFI shell is not available on secure SKU

boards. Follow the

Perform the steps that follow:

1. Use the files created in

2. Copy CapsuleApp.efi and Flash.cap to a microSD card (or USB stick) and

insert it into the slot on the board.

3. Connect the serial cable between the computer and the board. Set up a serial

console session (for example, PuTTY) and connect to the board's COM port at

115200 baud rate.

4. Configure the serial console session to recognize special characters. For example, if

you are using PuTTY, you must explicitly enable special characters. In the PuTTY

Configuration options, go to the Terminal > Keyboard category and set the

Function keys and Keypad option to SCO. You may also set Backspace to the

Control-H key.

5. Power on the board. Enter the EFI shell before grub starts by pressing F7.

6. The serial console displays a boot device selection box (below).

Select UEFI Internal Shell.

Intel® Quark™ SoC X1000 Board Support Package (BSP)

Build and Software User Guide

Section Error! Reference source not found.

Section

8.0.

procedure instead.

Document Number: 329687-011US

May 2017

Table of Contents