Dispensing Cold Water - Whirlpool 8LIECH-SC-SSS-5L-W User Manual

8LIECH-SC-SSS-5L-W
Turn the switches at the back of the dispenser to ON.
• The red switch controls the hot water. If you do not want hot water, leave this
switched OFF.
• The blue switch controls the cold water. If you do not want cold water, leave this
switched OFF.
• The yellow switch controls the LED night lights. Turn it ON or OFF as desired.
NOTE: For the unit to operate properly, the probe head must sit on the bottle and the
door must be closed.
NOTE: It will take a few minutes to fill the reservoirs with water. During this time, the
pump may turn on and off, this is normal.
NOTE: Each time you dispense water from the taps, the pump will turn on to refill the
tanks. This is normal.
NOTE: Self cleaning works every four hours for a short time. The self cleaning pump
sound is normal.

Dispensing Cold Water

NOTE: After setup, it will take over one hour to get the water to its coldest temperature.
During this time, the compressor may run continuously as the refrigeration system
builds the "Ice Bank"; this is normal.
1. Position the container you are wishing to fill with water, securely below the cold water
tap.
• The right triangle below the cold water control indicates the location of the cold
water tap (See the
• The circular shapes in the drip plate help align the flow of water. This unit
dispenses water at a fast rate. To avoid splashes, hold the cup as close to the tap
as possible.
2. Press the right control downward to start dispensing water.
3. Release the control once desired fill level is achieved.
PARTS & FEATURES
section).
P a g e 1 0