Dispensing Hot Water; Replacing An Empty Bottle - Whirlpool 8LIECH-SC-SSS-5L-W User Manual

8LIECH-SC-SSS-5L-W

Dispensing Hot Water

NOTE: After setup, hot water will be available in 15-20 minutes.
1. Position the container you are wishing to fill with water, securely below the hot water
tap.
• The left triangle below the hot water control indicates the location of the hot water
PARTS & FEATURES
tap (See the
• The circular shapes in the drip plate help align the flow of water. To avoid splashes,
hold the cup as close to the tap as possible.
2. Push the hot water release button (red) inward and press the control downward to start
dispensing water.
3. Release the control once desired fill level is achieved.

Replacing an Empty Bottle

Note: When your water bottle is empty, the EMPTY BOTTLE lights will blink until a fresh
bottle is installed. You may also hear a sucking sound when the bottle is empty and needs
changing. This is normal and is another way to be alerted that your bottle is empty and
needs to be replaced.
Replace the bottle as soon as you notice that it is empty.
There may be a small amount of water left in the bottle. Adjust length of telescopic probe
to allow offset portion to pump water from the lowest point in the bottle. Usually it is a
rounded corner. You should have less then 1 ounce of water left under normal operation.
To remove an empty bottle:
• Open the door and slide the bottle out.
To install fresh bottle:
• Place the fresh bottle in front of the tray.
• Clean the fresh bottle using a soft cloth and warm soapy water.
• Remove the entire plastic cap from the top of the bottle.
• Remove probe from old bottle and insert into the fresh bottle.
WARNING
Excessive Weight Hazard
Use two or more people to move and install bottles.
Failure to do so can result in back or other injury.
section).
P a g e 1 1