Model # 7LIECK-W-WL: Page 2 SAFETY PRECAUTIONS Your safety and the safety of others are very important. We have provided many important safety messages in this manual and your appliance. Always read and follow all safety messages. This is the safety alert symbol.
Model # 7LIECK-W-WL: Page 3 • Position the back of the dispenser no closer than 4 inches from the wall and permit free airflow between the wall and the dispenser. There must be at least 4 inches clearance on the sides of the dispenser to permit airflow.
Model # 7LIECK-W-WL: Page 4 TABLE OF CONTENTS Safety Precautions Safety Precautions-Electrical Requirements Key Information for Future Use Specifications Parts & Features Assembly Cleaning prior to initial use Installation Installing the Correct Bottle Receptacle Operation Proper Care & Cleaning Troubleshooting...
Model # 7LIECK-W-WL: Page 5 SPECIFICATIONS Power Supply 1.5 Amp Refrigerant Type R-134A Cold Water Power 100 Watts Cold Capacity / Hour 4 L / 1.05 Gallon Cold Temp Range 3°C - 10°C / 37.4°F - 50°F 91.3 H × 27.5 W × 28.6 D(cm) Dimensions 35.9 H ×...
Model # 7LIECK-W-WL: Page 6 ASSEMBLY 1. Remove the dispenser from packaging. 2. Lay the dispenser on its back. 3. Place the cooler in an upright position. Unpack the drip tray and insert it into the dispenser. 4. Properly dispose of all the packaging.
Model # 7LIECK-W-WL: Page 7 CLEANING PRIOR TO INITIAL USE To remove any odors or dust that may have accumulated during shipment, you must clean the dispenser prior to first use. DO NOT PLUG THE COOLER INTO AN ELECTRICAL POWER OUTLET Time Required: 40 minutes.
Model # 7LIECK-W-WL: Page 8 INSTALLATION 1. Put the dispenser upright. 2. Place the dispenser on a hard and level surface in a cool shaded location near a grounded wall outlet. Notice: Do NOT plug in the power cord yet.
Model # 7LIECK-W-WL: Page 9 INSTALLING THE CORRECT BOTTLE RECEPTACLE If your water bottle Then use this looks like this bottle receptacle This model comes with a Probe Receptacle (1). No changes are required. The probe will push the plug out of the way when you place the bottle into the receptacle.
Model # 7LIECK-W-WL: Page 10 OPERATION IMPORTANT This unit is intended for water dispensing only. Do NOT use other liquids. Do NOT use for other purposes. Warranty is void if used with any other liquids such as coffee, tea, juices, beer or wine.
Model # 7LIECK-W-WL: Page 11 Initial Rinsing of Water Lines This unit has been tested and sanitized prior to packing and shipping. During transit, dust and odors can accumulate in the tank and lines. You must dispense and dispose at least one quart of water prior to drinking any water dispensed from this unit.
Model # 7LIECK-W-WL: Page 12 PROPER CARE & CLEANING General Cleaning Perform: As needed Time Required: 5 minutes. Note: Do NOT use abrasive materials or chemical cleaners. 1. Clean the cabinet surfaces using a soft cloth and warm soapy water, then rinse.
Model # 7LIECK-W-WL: Page 13 9. Fill the reservoir with 1 gallon tap water. 10. Remove the water from the reservoir by dispensing it from both taps into a pitcher. 11. Replace all parts. WARNING Excessive Weight Hazard Ask two or more people to move and install the water cooler and the bottles.
Model # 7LIECK-W-WL: Page 14 TROUBLESHOOTING Dispenser is not operating. • Make sure that the power cord is properly connected to a working outlet. Water is leaking. • Replace water bottle. Most common cause is a cracked bottle. • Call 1-855-5WHIRL5 for assistance.
Model # 7LIECK-W-WL: Page 15 LIMITED WARRANTY Electrotemp Technologies Inc., (“Vendor”) warrants to the original purchaser of this dispenser, and to no other person, that if this dispenser is assembled and operated in accordance with the printed instructions accompanying it, then for a period of one (1) year from the date of purchase, all parts in such dispenser shall be free from defects in material and workmanship.