Registration Operation - Canon Inner Booklet Trimmer-A1 Service Manual

2
Technology > Controls > Registration operation

Registration operation

The sequence of registration operation is described below.
1. Drive the front estrangement motor (M103) before the center bound booklet is fed from the
saddle unit to separate the inlet roller (lower).
2. Drive the feed motor (M101) when the booklet passed from the saddle unit reaches the
inlet sensor (S101).
3. When the booklet reaches the inlet roller, drive the press motor (M105) and separate the
press roller (upper). Then drive the front estrangement motor (M103) and press and feed the
booklet with the inlet roller.
4. When the booklet reaches the trimming position, drive the rear estrangement motor (M104)
and separate the paper delivery roller (upper).
Also, drive the registration motor (M102) and move the registration unit to the registration
start position. At the same time, drive the stopper solenoid (SL101) and lift the registration
guide.
5. Feed the booklet to the registration start position and drive the front estrangement motor to
separate the inlet roller (lower).
6. After separating the inlet roller, drive the registration motor (M102) to register.
Paper delivery roller (upper)
Press motor (M105)
Rear estrangement
motor (M104)
Press roller (upper)
2
Technology > Controls > Registration operation
Feed motor (M101)
Front estrangement
motor (M103)
Inlet sensor (S101)
Inlet roller (lower)
F-2-9 F-2-9
Registration guide
2-8
Registration motor (M102)
F-2-10 F-2-10
2-8