Parts Replacement and Cleaning Procedure > Periodic Parts Replacement, Consumable Parts, and Cleaning Parts > Removing the scratch prevention sheet (rear)
8) Remove E ring, pulley, parallel pin, and bearing at the front side.
9) Remove E ring and bearing at the rear side. Remove the belt and roller unit, and remove the scratch prevention sheet (rear).
Note:
When installing the paper
eject pass unit, attach so
that the roller unit's paddle
(center) is on the bottom
side with the projection
of the pressure roller unit
positioned at the bottom of
the stopper solenoid lever.
4
Parts Replacement and Cleaning Procedure > Periodic Parts Replacement, Consumable Parts, and Cleaning Parts > Removing the scratch prevention sheet (rear)