Table of Contents
Advertisement
Operation space requirements
Introduction
The minimum open space from all sides of the printer required for normal operation,
maintenance and safety is shown in this document.
All printers must be installed directly on a rigid floor. For XT printers the precise alignment and
level of the two joined tables will be compromised if the floor support is flexible. (Coated)
Concrete is the recommended floor material. Carpeted or wood floors are not acceptable! Please
contact your Canon representative in case of doubt.
If you require an illustration of the location of the printer and RMO feet, see the web site at
"https://graphiplaza.cpp.canon/support/service-support/"
Operation space for the GT
[3] Recommended Operating Space for Arizona 1300 Series GT Printers
NOTE
The area around the printer must be kept clear of obstructions.
Cables and compressed Air tubing must be managed to prevent tripping (use the supplied
rubber cable protectors).
Operation space requirements
Chapter 4 - Specifications and Requirements
27
Advertisement
Table of Contents
