Canon Inner Booklet Trimmer-A1 Service Manual page 57

5
Installation > Installation Procedure > Making Preparations for Installing the Finisher
6
6) Using a nipper, cut out the face part of the waste paper
box on the inner cover.
8
8) At the back of the saddle unit, pull out one connector, and then remove the harness from the harness guide.
And then, close the four harness guides. (The closed four harness guides are no longer required.)
x6
x1
5
Installation > Installation Procedure > Making Preparations for Installing the Finisher
7
7) Draw out the saddle unit.
F-5-8 F-5-8
F-5-7 F-5-7
F-5-9 F-5-9
5-4
5-4