Setting Measurement Parameters - Commtest Instruments vbBalancer Instrument Reference Manual

Setting Measurement Parameters

When you select a measurement type e.g. Spectrum Waveform from
the Measure Menu the default parameters display on-screen.
Spectrum measurement setup showing default parameters
Example:
From the Main Menu press
•
press
Press
•
Paramset.
The default parameters for a spectrum measurement are
•
displayed. To change a parameter value press the key
beside the value's on-screen label. This will cause the
parameter to cycle through the available options, or it will
open a sub-menu where you enter a value via the keypad or
select a value from a list. If you have opened a sub-menu
save your changes by pressing
Spectrum Waveform.
to display hint labels then press
Section 7: Setting Measurement Options
Measure Vibration then
Create New
75