Drum With Bearing; Description - Electrolux T4190 Service Manual

Description

The drum is rear suspended in a bearing
where the bearing housing is mounted in
the bottom of the drum. The bearing shaft is
mounted on the chimney.
At the front the drum rests on two supporting
rollers which are mounted on a supporting rail.
Replacing supporting rollers, bearing or drum
1. Disconnect the power to the dryer.
2. Demount top plate.
3. Remove filter A, fig. 1.
4. Remove door by demounting top hinge.
Note! Only unscrew the two screws holding
the hinge. Do not unscrew screw A as it
secures the thread plate on the back of the
front plate. Get a good grip on the door - it is
heavy, fig. 2.
Continued on the following page

Drum with bearing

1
A
2
57
B