Electrolux T4190 Service Manual page 42

42
Replacing parts on transmission
1. Disconnect the power supply from
the dryer.
2. Dismount drum belt and motor.
3. Fig. 1. Dismount spring B.
4. Fig. 1. Dismount transmission belt C.
5. Fig. 1. Dismount snap ring D,
washer and arm with idler.
6. Fig. 1. Dismount snap ring, washer,
bearings and idler on dismounted
arm.
7. Fig. 1. Dismount plastic bearing
ring E.
8. Fig. 2. Check that there is no burr
on the motor bearing shield F -
if necessary remove burr with a file.
9. Mount plastic bearing ring E.
10. Mount idler, bearings, washer and
snap ring on arm.
11. Fig. 3. Mount arm G with idler and
washer on the motor.
12. Mount snap ring D.
13. Mount transmission belt C.
14. Fig. 4. Mount new spring. It is
important that the spring is
mounted in the outer hole.
15. Mount the complete motor.
16. Mount drum belt.
17. Assemble the dryer and test it.
18. Check that the belts go correctly
around the wheel.
Note!
In order to mount the idler A turn the
arm back and forth, lubricate the shaft end
with copper grease if necessary.
Do not hit or use excessive force on
!
the arm
Motor and transmission
1
E
2
3
4
A
B
C
D
F
G