Drum With Bearing - Electrolux T4900 Service Manual

Replacing supporting rollers
1. Disconnect the power supply to the dryer.
2. Open and remove the filter door.
Fig. 1 Remove the finger guard by unscrewing
the 2 screws A, fig. 1.
3. Fig. 2 Service cover plates B.
4. Undo the 8 screws in each service cover
plate (do not loosen them completely).
5. The service cover plates are removed.
6. Fig. 3 Open the door, lift the drum and insert
a wedge C between the front and the drum so
that the supporting rollers are relieved of the
pressure of the drum.
7. Fig. 4 Dismount screw P with washer
and bush and supporting rollers can be
dismounted/replaced.
When mounting: Protect the screw P with
Omnifit Seal 46M or similar quality.
Tighten the screw P with 30 Nm.
8. Reassemble the dryer.
9. Connect the power supply.
Function check
Function check the dryer, see section Periodic
maintenance.
78

Drum with bearing

1
A
2
B
3
C
4
P
Service
manual
B