Electrolux T4190 Service Manual page 51

Changing to natural gas/bottled gas
If the machine is to be converted to another
type of gas, the gas nozzle must be replaced,
see tables in section "Adjusting the dryer",
chapter "Gas installation".
Changing the nozzle
Before starting follow the steps on the previous page,
chapter "Before replacement".
1. Unscrew the back plate.
2. Dismount the electrode wire on the left
side of the heat box, fig. 1.
3. Dismount the compression nut and the
compression ring. Pull the coupling from
the nozzle, fig. 2.
4. Unscrew the 8 screws of the heat element
box.
5. Lift the cover upwards and pull it to the
right - still sitting on the edge.
6. Dismount the nozzle and replace it
with the right dimension, see tables
in section "Adjusting the dryer", chapter
"Gas installation".
7. Assemble in the opposite order as
described above.
Replacing gas burner
Before starting follow the steps on the previous page,
chapter "Before replacement".
1. Follow step 1-5 above.
2. Unscrew the nozzle and the 2 screws in
the burner bracket (left side), fig. 3.
3. Unscrew the 2 screws which are located
at the bottom of the heat box - one at
each side of the burner. Loosen the 2
screws above, fig. 3.
Heating
1
2
3
51
Burner
bracket