Reset Button - HP ProCurve 420 Installation And Getting Started Manual

Introducing the hp procurve wireless AP 420 ww/na
Back of the Access Point
Note that if the access point is connected to a PoE source device and also
connected to a local power source through the AC power adapter, PoE will
be disabled.

Reset Button

This button is used to restore the factory default configuration. When the
Reset button is pressed, any configuration changes you may have made
through the access point console, the web browser interface, and SNMP
management are removed, and the factory default configuration is restored to
the access point. For the specific method to restore the factory default
configuration, see "Restoring the Factory Default Configuration" in chapter 4,
"Troubleshooting" of this manual.
1-7