HP ProCurve 420 Installation And Getting Started Manual page 33

Type end to exit configuration mode, and then enter the show interface
6.
ethernet command to display the access point's default IP configuration,
including IP address, subnet mask, and default gateway. The following
illustration shows the default settings.
HP Procurve Access Point wl420#show interface ethernet
Ethernet Interface Information
========================================
IP Address
Subnet Mask
Default Gateway
Primary DNS
Secondary DNS
Speed-duplex
Admin status
Operational status
HP Procurve Access Point wl420#
Type configure to enter configuration mode, then type interface ethernet to
7.
access the Ethernet interface-configuration mode.
HP Procurve Access Point wl420#configure
HP Procurve Access Point wl420(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
HP Procurve Access Point wl420(if-ethernet)#
Type ip address ip-address netmask gateway, where "ip-address" is the
8.
access point's IP address, "netmask" is the network mask for the network,
and "gateway" is the default gateway router. Check with your system
administrator to obtain an IP address that is compatible with your
network.
HP Procurve Access Point wl420(if-ethernet)#ip address 192.168.1.1
255.255.255.0 192.168.1.254
Getting Started With Access Point Configuration
: 0.0.0.0
: 255.255.255.0
: 0.0.0.0
: 0.0.0.0
: 0.0.0.0
: 100Base-TX Full Duplex
: Up
: Up
3-3