Led Behavior - HP ProCurve 420 Installation And Getting Started Manual

Installing the wireless AP 420 ww/na
Installation Procedures
2.

LED Behavior:

2-6
Check the LEDs on the
Power LED
When the access point is powered on, it performs its diagnostic self test.
The self test takes approximately 50 seconds to complete.
During the self test:
• The 10/100BASE-T and Wireless LEDs go off and then may come on
again during phases of the self test. For the duration of the self test,
the Power LED blinks.
When the self test completes successfully:
• The Power LED remains on.
The 10/100BASE-T and Wireless LEDs on the top of the access point go
•
into their normal operational mode:
– If the ports are connected to active network devices, the LEDs
should be on.
– If the ports are not connected to active network devices, the LEDs
will stay off.
If the LED display is different than what is described above, especially if
the Power LED does not stop blinking, the self test has not completed
correctly. Refer to chapter 4, "Troubleshooting" for diagnostic help.
access point as described below.
Ethernet LED
Wireless LED