HP ProCurve 420 Installation And Getting Started Manual page 34

Getting Started With Access Point Configuration
9.
10. Type configure to return to global configuration mode, and then type
11. Set the Service Set Identifier (SSID) to identify the communications
3-4
Type exit to leave configuration mode, then enter the show interface
wireless g command to display the access point's default wireless config-
uration, including wireless communication domain, radio channel, and
operation status. The following illustration shows the default settings.
HP Procurve Access Point wl420(if-ethernet)#exit
HP Procurve Access Point wl420#show interface wireless g
Wireless Interface Information
===========================================================
----------------Identification-----------------------------
Description
SSID
Channel
Status
----------------802.11 Parameters--------------------------
Transmit Power
Max Station Data Rate
Fragmentation Threshold
RTS Threshold
Beacon Interval
DTIM Interval
Maximum Association
----------------Security-----------------------------------
Closed System
Multicast cipher
WPA clients
Encryption
Default Transmit Key
Static Keys :
Key 2: EMPTY Key 3: EMPTY
Authentication Type
===========================================================
HP Procurve Access Point wl420#
interface wireless g to access the wireless interface-configuration mode.
HP Procurve Access Point wl420#configure
HP Procurve Access Point wl420(config)#interface wireless g
HP Procurve Access Point wl420(if-wireless g)#
domain for the access point. Type ssid identifier, where "identifier" can
consist of up to 32 alphanumeric characters and is case sensitive.
HP Procurve Access Point wl420(if-wireless g)#ssid wl420
HP Procurve Access Point wl420(if-wireless g)#
: Enterprise 802.11g Access Point
: Enterprise Wireless AP
: 0 (AUTO)
: Disable
: FULL (17 dBm)
: 54Mbps
: 2346 bytes
: 2347 bytes
: 100 TUs
: 2 beacons
: 64 stations
: DISABLED
: WEP
: SUPPORTED
: DISABLED
: 1
Key 4: EMPTY
: OPEN