HP ProCurve 420 Installation And Getting Started Manual page 10

Introducing the hp procurve wireless AP 420 ww/na
Top of the Access Point
Access Point State
LEDs
10/100-T On (green)
On (amber)
Off
Blinking*
Wireless On
Off
Blinking*
* The blinking behavior is an on/off cycle once every 1.6 seconds, approximately.
1-4
Meaning
The LAN port is enabled and receiving a link indication from 100 Mbps device.
The LAN port is enabled and receiving a link indication from 10 Mbps device.
The LAN port has no active network cable connected, or is not receiving a link beat.
Otherwise, the port may have been disabled through the access point console, or the
web browser interface.
The LAN port is transmitting or receiving traffic.
The wireless interface is enabled and receiving a link indication from a wireless client
The wireless interface is not receiving a link beat. Otherwise, the wireless interface
may have been disabled through the access point console, or the web browser
interface.
The wireless interface is transmitting or receiving traffic.