Auto-Sleep Function; Photo Safety Eye - Gfp 44TH Operating Manual

21. Auto Sleep Function
1. If the motor has been idle for Three (3) hours without running, the machine
will go into STAND BY mode. The temperature drops to 176° F and the
ready light flashes.
a. To resume operation, turn the MOTOR switch to the FWD position, then back to
the middle OFF position.
b. Allow machine to reheat to proper temperature and Ready light to
illuminate solid.
2. If the motor has been idle for four (4) hours without running, the machine will
go into SLEEP mode, and the heaters are turned off.
a. To resume operation, turn the ON/OFF switch to OFF position, then back to
ON and allow the ready light to come on.

22. Photo Safety Eye

1. When the machine switch is set to FWD, it is possible to normally adjust speed of the
machine. If the photo safety eye is blocked, the motor will stop and the machine will
not operate. To reset, place the motor switch is in the center position. When pressing
the foot switch, the machine will operate and the speed can be adjusted.
2. When the motor switch is set to reverse rotation, the machine will only operate when
pressing the foot switch; the machine will operate at 3ft/min.
3. When the motor switch is in the center position, the photo safety eye will be reset. When
pressing the foot switch, the machine will operate and speed can be adjusted. The
rotation direction will be in the forward rotation.
Gfp 44TH
21
October 2017