Attach Safety Shield; Attach Print Hold Down Clamp - Gfp 44TH Operating Manual

7h. Attach Safety Shield
1. Hold the handles at both ends of the safety shield and align mounting block on safety
shield with spring loaded pin in left side frame. Move shield in the direction of the arrow
below
2. Align right mounting block on safety shield with locating pin on right side frame
3. The safety shield may be rotated up for access to the rollers.
7i. Attach Print Hold Down Clamp
1. Rotate the safety shield up and unscrew the thumbscrews at the both ends of the feed
table. Then insert the print hold down clamp under each thumbscrew and tighten. To
remove, rotate the safety shield up and unscrew the thumbscrews at the both ends of
the feed table, and remove the print hold down clamp, then tighten the thumbscrews.
Thumbscrew
Gfp 44TH
11
October 2017