Roller Gap Adjustment; Operation - Gfp 44TH Operating Manual

10. Roller Gap Adjustment

1. The roller gap adjustment handle (see Fig.) is located on the right-side cover of the
laminator and is used to adjust the roller gap and pressure.
2. There are four mounting gap settings; 1/4" (6mm ） , 3/16" (5mm ） ， 1/8" (3mm ） and
1/16" (1.5mm). Zero is for full pressure when laminating.
Caution! When not in use, set the Gap handle to the fully open position. When warming
up the machine, set the Gap handle to ZERO and turn the motor speed to 1/2.

11. Operation

Connect the attachment plug provided with the laminator to a suitably grounded outlet
1.
only. This machine must have reliable earth wire to ensure the safety of the machine
during operation.
2. Contact an electrician should the attachment plug provided with the laminator not
match the receptacles at your location.
3. Ensure that the voltages of the power supply you are using match the rated working
voltages before operations. Do not use incorrect power supply.
4. Make sure the Motor function switch on the front control panel is in the center, stop
position.
5. Connect the power cord to the wall outlet and turn on the power switch to ON as
shown in the figure below. You should hear three audible beeps, this means the
machine is in the operation mode. If you only hear two beeps, check the Motor
function switch for the proper location.
Gfp 44TH
14
October 2017