DL-HDE100 Owners Manual Important Safety Instructions » Please completely read and verify you understand all instructions in this manual before operating this equipment. » Keep these instructions in a safe, accessible place for future reference. » Heed all warnings. » Follow all instructions.
The DL-HDE100 is sold only as a set. The individual transmitter and receiver are not compatible with other HDBaseT devices due to proprietary PoE circuitry.
Front Panel Diagnostic LEDs: The DL-HDE100 provides four blue LEDs to indicate the current operating status and to assist troubleshooting an installation. Power: Solid, the DL-HDE100 extender is receiving power from the power supply or from the remote extender via Category 6 cabling.
Front Panel Diagnostic LEDs: The DL-HDE100 provides four blue LEDs to indicate the current operating status and to assist troubleshooting an installation. Power: Solid, the DL-HDE100 extender is receiving power from the power supply or from the remote extender via Category 6 cabling.
Connect the display to the HDMI output on the DL-HDE100 receiver labeled HDMI OUT using an HDMI cable that is less than or equal to 5 meters in length. It is recommended to keep the DL-HDE100 receiver near the display input as it is not recommended that an active HDMI cable be used on the HDMI output on the DL-...
DL-HD70 Owners Manual HDBaseT Connection Connect one end of a Category cable to the DL-HDE100 transmitter labeled TWISTED PAIR, then connect the other end of the Category cable to the DL-HDE100 receiver labeled TWISTED PAIR Twisted Pair Wiring TIA/EIA-568B Use TIA/EIA-568B wiring for Category 6...
Attach the IR emitter to the IR receiver of the display device, insert the TS 3.5 mm plug of the emitter to the IR OUT port of the DL-HDE100 receiver. Insert the TS 3.5 mm plug of the IR receiver (eye) to the IR IN port of the DL-HDE100 transmitter.
DL-HD70 Owners Manual Apply Power Connect the included power supply to the transmitter or receiver and lock the power supply to the power connector by twisting the locking collar clockwise. It is not required that both the transmitter and receiver be powered simultaneously.
DL-HD70 Owners Manual HDMI Extension / Control System IR Control Control System / Switcher IR-AC CABLE DL-HDE100 TRANSMITTER HDMI CATx DL-HDE100 RECEIVER Display IR Emitter...
DL-HD70 Owners Manual HDMI Extension / Control System RS232 Control Laptop Control System DL-HDE100 TRANSMITTER HDMI CATx RS232 DL-HDE100 RECEIVER Display...
DL-HD70 Owners Manual Technical Specifications Supported Audio and Video Video Compliance HDMI 2.0, HDCP 2.2, and CEC (Consumer Electronics Control) Embedded Audio Up to PCM 8 channel, Dolby Digital TrueHD, and DTS-HD Master Audio IR Carrier Frequency Range 33-55kHz at 5 volts RS232 Baud Rate Up to 115200 baud HDBaseT Signal Characteristics...
Page 16
Thank you for your purchase. For Technical Support please call our toll free number at 800-530-8898 or email us at supportlibav@libav.com www.libav.com is a brand of: 11675 Ridgeline Drive Colorado Springs, Colorado 80921 USA Phone: 719-260-0061 Fax: 719-260-0075 Toll-Free: 800-530-8998...
Need help?
Do you have a question about the DL-HDE100 and is the answer not in the manual?
Questions and answers