Link Procedure - FUTABA T6L Sport Instruction Manual

1
Place the transmitter and the receiver
close to each other within 20 inches(half
meter).
2
To activate the Link Mode.
Operate both sticks fully in the
bottom and the inside, in the
power off state.
3
Immediately turn on the receiver power.
The receiver will enter the linking state
(LED blinks red) about 3 seconds after
the receiver power is turned on.
4
If the receiver ID is displayed in the transmitter and the LED changed from red blinking to
a steady green light, linking is complete. (The receiver linking wait state ends in about 3
seconds.)
5
Check system operation. If the transmitter and receiver are not linked, try linking again.
*If there are many T-FHSS Air systems turned
other T-FHSS Air transmitter/receiver be link-
if you do not notice this situation. In order to
under control by your transmitter.
Less than 20 inches
Turn on the power switch.
In "Link" Mode
WARNING
-
After the linking is done, please cycle receiver
power and check that the receiver to be linked
is really under the control of the transmitter.
Don't perform the linking procedure with mo-
tor's main wire connected or with the engine
operating as it may result in serious injury.
-
-
Transmitter in
"Link Mode"
Transmitter LED blinking
Once 1s ON - Once 1s OFF
Enters the link mode
for 15 seconds
Receiver ON
17