IEI Technology WAFER-UTL3 User Manual page 93

Device Mode [RS232]
Use the Device Mode option to select the Serial Port 1 signaling mode.
RS422
RS232
RS485
5.3.4.1.2 Serial Port 2 Configuration
Serial Port [Enabled]
Use the Serial Port option to enable or disable the serial port.
Disabled
Enabled
Change Settings [Auto]
Use the Change Settings option to change the serial port IO port address and interrupt
address.
Auto
IO=2F8h;
IRQ=3
IO=3F8h;
IRQ=3, 4,
5, 6, 7, 9,
10, 11, 12
IO=2F8h;
IRQ=3, 4,
5, 6, 7, 9,
10, 11, 12
Page 80
Serial Port 1 signaling mode is RS-422
D Serial Port 1 signaling mode is RS-232
EFAULT
Serial Port 1 signaling mode is RS-485
Disable the serial port
D Enable the serial port
EFAULT
D The serial port IO port address and interrupt address
EFAULT
are automatically detected.
Serial Port I/O port address is 2F8h and the interrupt
address is IRQ3
Serial Port I/O port address is 3F8h and the interrupt
address is IRQ3, 4, 5, 6, 7, 9, 10, 11, 12
Serial Port I/O port address is 2F8h and the interrupt
address is IRQ3, 4, 5, 6, 7, 9, 10, 11, 12
WAFER-ULT3/ULT4 3.5" SBC