Table of Contents
Advertisement
Neutralizing the control sticks
Brake spring and ratchet
Control sticks centering force
VERTICAL
VERTICAL
VERTICAL
HORIZONTAL
HORIZONTAL
HORIZONTAL
S1002.PRO_jh_V1
Closing step by step:
Check if the upper and the lower part of the transmitter housing are
correctly coupled and the tiny cables are properly placed.
Screw the housing screws in their original position.
Connect the battery holder.
Both control sticks can be set from neutralizing to non-neutralizing.
Neutralizing step by step:
Locate in the left control stick gimbal the screw surrounded by a
white circle in the picture.
Turn the screw toward the inside of the transmitter until the relevant
control stick can move freely from stop to stop, or turn it outward
until the control stick resets itself independently.
Note
The right control stick gimbal is specular to the left one, so that here
the screw is located left under the middle.
The outboard screw of the two marked in the figure adjust the brak-
ing force.
The inboard screw adjusts the strength of the ratchet for the respec-
tive control stick.
Note
The right control stick gimbal is specular to the left one, so that here
the screws are located right on the top side.
The control sticks' restoring force can also be adjusted. The adjust-
ment is located next to the return springs.
By turning the respective adjust screw the spring force can be
adjusted.
Right turn = return harder
Left turn = return softer
Note
The right control stick gimbal is specular to the left one, so that here
the screws are located left in the middle.
17 / 28
Advertisement
Table of Contents
