Huawei Quidway S1700 Series Web User Manual page 31

Quidway S1700 Series Ethernet Switches
Web User Manual
Table 4-2 Parameters of Configuring Connections by Port List
Title
Port
Type
Name
Admin
Media Type
Autonegotiation Allows auto-negotiation to be enabled/disabled. When auto-negotiation is
Speed/Duplex
Flow Control
1. Click Interface > Port > General. Select Configure by Port List from the Action List.
Figure 4-2
2. Modify the required interface settings. Go to next page by clocking
3. Click Apply. It takes effect immediately.
View the port status by clicking Interface > Port > General and selecting Show Information
from the Action List.
----End
Issue 01 (2011-11-17)
Auto-negotiation must be disabled before you can configure or force an interface to use
the Speed/Duplex mode or Flow Control options.
When using auto-negotiation, the optimal settings will be negotiated between the link
partners based on their advertised capabilities. To set the speed, duplex mode, or flow
control under auto-negotiation, the required operation modes must be specified in the
capabilities list for an interface.
The 1000BASE-T standard does not support forced mode. Autonegotiation should
always be used to establish a connection over any 1000BASE-T port or trunk. If not used,
the success of the link process cannot be guaranteed when connecting to other types of
switches.
The Speed/Duplex mode is fixed at 1000full on the Gigabit SFP ports. When
auto-negotiation is enabled, the only attributes which can be advertised include flow
control.
Description
Port identifier.
Indicates the port type. (1000Base-T, 1000Base SFP)
Allows you to label an interface. (Range: 1-64 characters)
Allows you to manually disable an interface. You can disable an interface
due to abnormal behavior (e.g., excessive collisions), and
then re-enable it after the problem has been resolved. You may also
disable an interface for security reasons.
Copper-Forced:Always uses the built-in RJ-45 port.
SFP-Forced: ways uses the SFP port (even if a module is not installed).
enabled, you need to specify the capabilities to be advertised. When
auto-negotiation is disabled, you can force the settings for speed, mode,
and flow control.The following capabilities are supported.
Allows you to manually set the port speed and duplex mode. (i.e., with
auto-negotiation disabled)
Allows automatic or manual selection of flow control.
is displayed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
4 Interface Configuration
.
26