Connecting The Mains Power - Tally Dascom 5130P User Manual

Tally Dascom 5130P

Connecting the Mains Power

Checking the printer voltage
Make sure that the device has been set according to your country's power supply voltage. To do this, check
the ratingplate at the back of the printer. Contact your dealer if the setting is incorrect.
Never switch on the printer if the voltage setting is incorrect; this may result in electrical
damage to the printer.
1. Make sure the printer and the computer are powered off.
2. Connect the power cord to the power receptacle at the back of the printer, as shown as below. Ensure the
power cord is securely connected. Connect the power cord plug to a mains socket.
3. Press the power switch to the "I" position to power on the printer. Upon power-on, all the five LEDs light
up briefly. After initialization, only the "ON" LED should light up.
4. Press the power switch to the "O" position if you wish to switch off the printer.
NOTE:
After switching off the printer, wait at least 5 seconds before switching on again. Otherwise, it may cause
•
damage to the printer.
Disconnect the power cord if the printer is not used for a long time.
•
11