Kontron FlexATX-KBL-S-C236 User Manual page 82

Sub-Screen Function
TraceHub Configuration Menu
Pch Thermal Throttling Control
SB Porting Configuration
DCI enable (HDCIEN)
DCI Auto Detect Enable
Debug Port Selection
GNSS
PCH LAN I219 Controller
DeepSx Power Policies
LAN Wake from DeepSx
Wake on LAN - (LAN3-I219)
SLP_LAN# Low on DC Power
K1 off
Wake on WLAN and BT Enable
Disable DSX ACPRESENT PullDown
UCSI/UCMC device
TraceHub Enable Mode
MemRegion 0 Buffer Size
MemRegion 1 Buffer Size
Thermal Throttling Level
DMI Thermal Setting
SATA Thermal Setting
www.kontron.com
FlexATX-KBL-S-C236 – Rev. 1.1
Description
When enabled, ACPI will
report UCSI/UCMC device
Select Enable, Disable or
Debugger
Select size of mem region 0
buffer
Select size of mem region 1
buffer
Determine if use Intel
suggested setting
Determine if use Intel
suggested setting
Determine if use Intel
suggested setting
SB Porting Configuration
When DCI enable, it is taken
as user consent to enable
the DCI which allows debug
over the USB3 interface
When set to Auto Detect, it
detect DCI being connected
during BIOS post time and
enables DCI
Select Kernel Debug Port
and report in ACPI DBG2
table
ISH – GNSS is connected to
ISH. Serial IO UART – GNSS
is connected to serial IO
Enable/Disable onboard NIC
Configure the DeepSx Mode
configuration
Wake from DeepSx by the
assertion of LAN_WAKE pin
Enable/Disable integrated
LAN to wake the system
Enable/Disable SLP_LAN#
Low on DC Power
Enable/Disable K1 off
feature (CLKREQ)
Enable/Disable PCI Express
Wireless LAN and Bluetooth
to wake the system
Disable PCH internal
// 82