Kontron FlexATX-KBL-S-C236 User Manual page 81

Sub-Screen Function
SPI1 Controller
UART0 Controller
UART1 Controller
UART2 Controller
GPIO Controller
Serial IO I2C IO Voltage
Select
I2C0
Settings
Connected Device
Serial IO I2C IO Voltage
I2C1 Select
Settings
Connected Device
Serial IO ChipSelect Polarity
SPI0
Settings
Serial IO Bluetooth Device
UART0
Settings
Wireless Charging
Mode
Hardware Flow
Control
Serial IO GPIO IRQ Route
GPIO
Settings
WITT/MITT Test Device
UART Test Device
Additional Serial IO devices
SerialIO timing parameters
www.kontron.com
FlexATX-KBL-S-C236 – Rev. 1.1
Description
Enables/Disables Serial IO
Controller
Enables/Disables Serial IO
Controller
Enables/Disables Serial IO
Controller
Enables/Disables Serial IO
Controller
Enables/Disables the GPIO
Controller
Select 1.8v or 3.3v for the
controller
Indicate what type of device
is connected to this serial IO
controller
Select 1.8v or 3.3v for the
controller
Indicate what type of device
is connected to this serial IO
controller
Sets initial polarity for
ChipSelect signal
Enables/Disables the
vendor Sensor
Set the wireless charging
mode
When enabled configures
additional 2 GPIO pads for
use as RTS/CTS signals for
UART
Route all GPIO to one of the
IRQ
Choose if WITT Device is
used and with which
controller
Choose if UART Test Device
is used and with which
controller
When enabled, ACPI will
report additional devices
connected to Serial IO
SerialIO timing parameters
(test only)
// 81