GE B30 Instruction Manual page 609

APPENDIX H
Table H–5: MAJOR UPDATES FOR B30 MANUAL REVISION AA2 (Sheet 2 of 2)
PAGE PAGE CHANGE
(AA1) (AA2)
3-8 3-8 Update
5-23 5-23 Add
5-31 5-31 Add
B- B- Update
H-7 H-7 Update
Table H–6: MAJOR UPDATES FOR B30 MANUAL REVISION AA1
PAGE PAGE CHANGE
(Z1) (AA1)
--- --- Add
2- 2- Update
2- 2- Update
8- --- Delete
--- 10- Add
--- D- Add
Table H–7: MAJOR UPDATES FOR B30 MANUAL REVISION Z1
PAGE PAGE CHANGE
(Y3) (Z1)
--- --- Add
--- --- Add
1-1 1-1 Add
1-5 1-5 Update
2-7 2-7 Update
5-23 5-23 Add
5-85 5-85 Update
5-89 5-89 Update
5-180 5-180 Add
Table H–8: MAJOR UPDATES FOR B30 MANUAL REVISION Y3
PAGE PAGE CHANGE
(Y2) (Y3)
-- xi Add
2-10 2-10 Update
5-119 5-119 Update
GE Multilin
DESCRIPTION
Updated Figure 3-10 Typical Wiring Diagram to include delta and wye voltage input options
Added Syslog Format section
Added Far-End Fault Indication (FEFI) section
Updated Modbus memory map and F codes
Updated product warranty from 24 months to 10 years
DESCRIPTION
Added content for IEC 60870-5-103 throughout document
Updated order codes
Updated specifications
Deleted chapter 8 on security, moving content to other chapters
Added Maintenance chapter, moving content from other chapters and adding new instructions to
replace the battery
Added new appendix on IEC 60870-5-103 interoperability
DESCRIPTION
Added CPU options U and V to order code tables in chapter 2, a note above Rear Terminal View
figure in chapter 3, and CPU Module Communications Wiring figure in chapter 3
Added Parallel Redundancy Protocol (PRP) to order code tables and specifications in chapter 2,
section 5.2.5d Settings > Product Setup > Communications > Network, section 6.3.1 Actual
Values > Status > PRP, and Appendix B Modbus table and F627 and F628 enumeration tables
Added General Cautions and Warnings to section 1.1.1
Revised section 1.3.1 on system requirements, including addition of support for Windows 7 and
Windows Server 2008
Updated several specifications
Added section 5.2.5e Routing
Updated Figures 5-23 and 5-24 Dual Breaker Control Scheme Logic, sheets 1 and 2
Updated Figure 5-25 Disconnect Switch Scheme Logic
Reinserted section 5.8.5c Remote Devices: ID of Device for Receiving GSSE/GOOSE Messages,
meaning the Settings > Input/Outputs > Remote Devices settings
DESCRIPTION
Added battery disposal information as chapter 0
Updated Bus Differential Pickup Level specification from 2.000 to 6.000 pu
Updated Bus Differential Pickup Level specification from 2.000 to 6.000 pu in section 5.6.3 Bus
Differential
B30 Bus Differential System
H.1 CHANGE NOTES
H
H-3