Connections Setup; Wan - D-Link User Manual

DSL-224 Wireless VDSL2 Router with ASDL2+ Support
User Manual

Connections Setup

In this menu you can configure basic parameters of the router's local area network and configure
connection to the Internet (a WAN connection).

WAN

On the Connections Setup / WAN page, you can create and edit connections used by the router.
By default, VDSL and ADSL connections of the Dynamic IP type are configured in the system.
They are assigned to the DSL port of the router. You can edit these connections or delete them.
!
Please reboot the router after creating, editing, or removing an ADSL WAN connection.
To create a new connection, click the Add button in the Connections List section. On the opened
page, specify relevant parameters.
To edit an existing connection, in the Connections List section, left-click the relevant line in the
table. On the opened page, change the parameters and click the APPLY button.
To disconnect a connection and establish it again, select the checkbox located to the left of the
relevant line in the table and click the Reconnect button.
On the Basic tab, mandatory settings of a WAN connection are displayed. To view all available
settings of the needed WAN connection, go to the All Settings tab.
To remove a connection, in the Connections List section, select the checkbox located to the left
of the relevant line in the table and click the Delete button. Also you can remove a connection on
the editing page.
Figure 45. The Connections Setup / WAN page.
Page 57 of 168
Configuring via Web-based Interface