DSL-2640U Wireless ADSL2+ Router with Ethernet WAN Support
User Manual
Connections Setup
In this menu you can configure basic parameters of the router's local area network and configure
connection to the Internet (a WAN connection).
WAN
On the Connections Setup / WAN page, you can create and edit connections used by the router.
By default, an ADSL connection of the Dynamic IP type is configured in the system. It is assigned
to the DSL port of the router.
!
Please reboot the router after creating, editing, or removing an ADSL WAN connection.
!
Prior to creating an Ethernet WAN connection, specify a LAN port that will be used as the
WAN port (see the WAN Remapping section, page 124 ).
Figure 43. The Connections Setup / WAN page. The simplified mode.
To edit an existing connection, click the EDIT button. On the opened page, on the Basic tab, the
mandatory settings of this WAN connection will be displayed. To view all available settings of the
WAN connection, go to the All Settings tab. Change the needed parameters and click the APPLY
button.
To disconnect a connection and establish it again, click the RECONNECT button.
To remove an existing connection and create a new one, click the CHANGE CONFIGURATION
button. Upon that the connection creation page opens.
To create several WAN connections, go to the advanced mode. To do this, click the ADVANCED
MODE button.
!
When connections of some types are created, the Connections Setup / WAN page is
automatically displayed in the advanced mode.
Page 57 of 174
Configuring via Web-based Interface