D-Link User Manual page 139

DSL-224 Wireless VDSL2 Router with ASDL2+ Support
User Manual
Parameter
IP version
Set as
Start IPv4 address /
Start IPv6 address
End IPv4 address /
End IPv6 address
Subnet IPv4 address /
Subnet IPv6 address
Set as
Start IPv4 address /
Start IPv6 address
End IPv4 address /
End IPv6 address
Subnet IPv4 address /
Subnet IPv6 address
Destination port
Set source port
manually
An IP version to which the rule will be applied. Select the relevant
value from the drop-down list.
Source IP Address
Select the needed value from the drop-down list.
The source host start IPv4 or IPv6 address.
If it is necessary to specify a single address, leave the End IPv4
address / End IPv6 address field blank.
You can choose a device connected to the router's LAN at the
moment. To do this, select the relevant IPv4 or IPv6 address from the
drop-down list (the field will be filled in automatically).
The source host end IPv4 or IPv6 address.
The source subnet IPv4 or IPv6 address. The field is displayed when
the Subnet value is selected from the Set as drop-down list.
Destination IP Address
Select the needed value from the drop-down list.
The destination host start IPv4 or IPv6 address.
If it is necessary to specify a single address, leave the End IPv4
address / End IPv6 address field blank.
You can choose a device connected to the router's LAN at the
moment. To do this, select the relevant IPv4 or IPv6 address from the
drop-down list (the field will be filled in automatically).
The destination host end IPv4 or IPv6 address.
The destination subnet IPv4 or IPv6 address. The field is displayed
when the Subnet value is selected from the Set as drop-down list.
Ports
A port of the destination IP address. You can specify one port,
several ports separated by a comma, or a range of ports separated by
a colon.
Move the switch to the right to specify a port of the source IP
address manually. Upon that the Source port field is displayed.
Page 139 of 168
Configuring via Web-based Interface
Description