Connections Setup; Wan - D-Link DIR-825/AC User Manual

DIR-825/AC Wireless AC1200 Dual Band Gigabit Router
User Manual

Connections Setup

In this menu you can configure basic parameters of the router's local area network and configure
connection to the Internet (a WAN connection).

WAN

On the Connections Setup / WAN page, you can create and edit connections used by the router.
By default, a Dynamic IPv4 connection is configured in the system. It is assigned to the WAN
port of the router. You can edit this connection or delete it.
To create a new connection, click the Add button in the Connections List section. On the opened
page, specify relevant parameters.
To edit an existing connection, in the Connections List section, left-click the relevant line in the
table. On the opened page, change the parameters and click the APPLY button.
On the Basic tab, mandatory settings of a WAN connection are displayed. To view all available
settings of the needed WAN connection, go to the All Settings tab.
To remove a connection, in the Connections List section, select the checkbox located to the left
of the relevant line in the table and click the Delete button. Also you can remove a connection on
the editing page.
To allow multicast traffic (e.g. streaming video) for a connection, in the IGMP section, select the
choice of the radio button which corresponds to this connection (only for connections of the
Dynamic IPv4 or Static IPv4 type).
To forbid multicast traffic for all WAN connections, select the Disable choice of the radio button.
To use one of existing WAN connections as the default IPv4 or IPv6 connection, in the Default
gateway section, select the choice of the radio button which corresponds to this connection.
Figure 58. The Connections Setup / WAN page.
Page 75 of 222
Configuring via Web-based Interface