Table of Contents
Advertisement
Network setup screen [Networks]
Configure network settings.
≥ The following information is required to configure network settings. Consult your network administrator.
j IP address
j Subnet mask
j Default gateway (when using a gateway server or router)
j HTTP port
j DNS primary and secondary server addresses (when using DNS)
≥ The unit does not support an IPv4/IPv6 switching function. (It only supports IPv4)
≥ A connection cannot be made unless the combination of the IP address, subnet mask, and gateway are correct.
≥ Establish a connection again after changing the settings.
1 DHCP
Whether the DHCP function is to be used is set by selecting [ON] or [OFF] here. Set the DHCP server in such a way
that the same IP address cannot be used by personal computers without the DHCP function or by other network
cameras.
For details on the server settings, consult your network administrator.
Factory settings: OFF
The IP address that was automatically assigned with DHCP can be viewed using the "Easy IP Setup Software".
(Windows only) The software can be downloaded from the support website below.
http://pro-av.panasonic.net/
≥ The network settings of the unit cannot be configured with the "Easy IP Setup Software".
2 IP address(IPv4)
Input the unit's IP address here when the DHCP function is not going to be used. Input an address that will not
duplicate an existing IP address which has been set for a personal computer or another network camera.
Factory settings: 192.168.0.10
≥ Multiple IP addresses cannot be used even when the DHCP function is used. For details on the DHCP server
settings, consult your network administrator.
3 Subnet Mask
Input the unit's subnet mask here if the DHCP function is not going to be used.
Factory settings: 255.255.255.0
44
Advertisement
Table of Contents
