Advertisement
Quick Links
Advertisement
Related Manuals for Panasonic AJ-YAC77P
Summary of Contents for Panasonic AJ-YAC77P
- Page 1 SDTI Interface Board F0400T50 @ VQT8801...
-
Page 2: Before Installation
Contents Introduction ......................2 Before installation ....................2 Connector section....................2 Installation ......................3 Precautions for SDTI use..................7 Specifications ....................... 7 Introduction This product is an SDTI interface board designed for use in the AJ-DE77, AJ-DE77H and AJ- DE77D models using Ver 3.0 or later of the Quick Cutter application. Installation of this product in the AJ-DE77, AJ-DE77H or AJ-DE77D enables digital data using the SDTI format* (digital data compression interface) to be input and output. -
Page 3: Installation
Installation Check that the power of the AJ-DE77, AJ-DE77H or AJ-DE77D (hereafter referred to as the “Quick Cutter” ) is OFF. Screws (x4) Remove the four screws securing the top panel of the Quick Cutter, then remove the panel. Remove the 12 screws securing the two side panels of the Quick Cutter, then remove the panels. - Page 4 Installation After threading the coaxial cables connected to the terminal board through points 1 and 2 as shown at right, replace the jack panel on the main unit. 1 1 Pass the cable through the oval-shaped hole. 2 2 Pull the cable out from the position shown. (AJ-DE77 only) Remove the two screws and two hexagonal bolts of the AV interface connector at the bottom rear of the Quick Cutter and...
- Page 5 Installation After setting NTSC or PAL for the P4 pin of the accessory SDTI board as shown in the jumper setting diagram, refer to the coaxial cable connection diagram and connect the coaxial cables. The connections with the board should be made in the following order: 1 Connect the coaxial cable (black) which was connected in step 7 to the S_IN1 connector on the SDTI card provided with the unit.
- Page 6 Installation Remove the 4 screws shown in the diagram at right and the right metal fitting grip of the Quick Cutter unit, then remove the F1 and F2 boards of the VTR unit. F1 board F2 board Screws (x4) Replace the two ROMs (IC2 and IC702) from the VTR units F2 board with the ROMs provided with the board.
-
Page 7: Specifications
Precautions for SDTI use ≥ Before handling the interface board and its ROMs, be absolutely sure to attach a grounding strap. ≥ Recording operations cannot be performed unless the SDTI input signals are DVCPRO (25 Mbps) format 4x or 1x transfer signals. ≥... - Page 8 DIVISION OF MATSUSHITA ELECTRIC CORPORATION OF AMERICA Executive Office: 3330 Cahuenga Blvd W., Los Angeles, CA 90068 (323) 436-3500 EASTERN ZONE: One Panasonic Way 4E-7, Secaucus, NJ 07094 (201) 348-7621 Mid-Atlantic/New England: One Panasonic Way 4E-7, Secaucus, NJ 07094 (201) 348-7621 Southeast Region:...