Screen Height Adjustment - Panasonic UB-5310 Operating Instructions Manual

Electronic board
Hide thumbs Also See for UB-5310:
Table of Contents

Advertisement

Screen Height Adjustment

The screen can be adjusted at 3 levels except for the lowest level. The lowest level of the board attachment frame is
designed for installation of the screen, so the printer cannot be attached at this level. Adjust the level of the screen
unit as follows.
Please lock the casters when you adjust the screen height. (Refer to page 5.)
1
Height
adjustment
handles
2
Board attachment
(lower)
3
14
Height
adjustment
handles
Slide
groove
Down
Lift
Step frame
Reinforce pipe
Slot 4
Slot 3
Slot 2
Slot 1
Loosen the height adjustment handles.
Hang the step frame on the reinforce pipe.
Lift the board attachment (lower) by stepping on
the step frame.
Slide along the slide groove.
Do not handle the tray.
Adjust the screen height with two persons after
installation.
Hang the screen in the desired slots of the slide
plates.
Slot
Adjustment
Slot 1
Available
Slot 2
Available
Slot 3
Available
Slot 4
Cannot be used
Do not use slot 4.
Slot 4 cannot be used for screen height adjustment.
Confirm both sides of the screen are hung in the
same height slots securely.
Screen Height
2000 mm
1875 mm
1750 mm

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents