Cleaning The Covers; Recaro® Seat; Settings - Otto Bock C2000 Instructions For Use Manual

Use

8.14.2.2 Cleaning the covers

Cleaning the cloth cover
INFORMATION
► Replace the cover when it shows signs of advanced wear.
► Should it be necessary to disinfect the cover, add a standard hygiene detergent during washing (e.g.
®
Sagrotan laundry hygiene detergent).
► In case of heavy incontinence, an additional incontinence barrier should be used. Please observe the care
and cleaning instructions for each incontinence barrier used.
1) Close the zipper on the cover before washing.
2) Wash the cover at 60 °C [140 °F] using a mild, environmentally friendly detergent.
Recommendation: Wash the cover using the delicate cycle at 40 °C [104 °F] to prevent excessive wear.
3) Allow to air dry. Do not use a clothes drier.
Cleaning the artificial leather cover
The artificial leather cover does not have to be removed for cleaning.
1) Wipe the artificial leather cover by hand using a damp cloth and mild, environmentally friendly detergent. Do
not wash in the washing machine.
2) Allow to air dry. Do not use a clothes drier.
3) As needed: For disinfection, wipe damp with a water-based disinfectant.
Cleaning the foam pads
1) Hand wash all foam components in warm water at 40 °C [104 °F] using a standard mild detergent. Do not use
fabric softener. Rinse thoroughly.
2) Allow to air dry. Do not expose to direct heat sources (e.g. sunlight, stove or radiator).
8.14.3 Recaro® seat
The Recaro® seat provides individually adjustable, comprehensive seating comfort.

8.14.3.1 Settings

32
Adjusting the lateral supports in the lumbar region
INFORMATION
This information only applies to the Recaro® LT model.
1) Turn the dial on the side of the backrest towards the front.
→ The two lateral supports are moved closer together.
2) Turn the dial on the side of the backrest towards the rear.
→ The two lateral supports are moved further apart.
Adjusting the pads
The seat surfaces X and W are equipped with a pull-out pad at the front of the seat bottom. The adjustment lever
for the pad is located below the seat bottom.
1) Pull the pad adjustment lever up and hold it there.
44 | Ottobock
Adjusting the back angle
1) Turn the knob on the right or left side of the back­
rest (see fig. 32, item 2).
2) Change the backrest angle to the desired position.
CAUTION! Note that the maximum backrest
angle is 30° while standing and 20° while driv­
ing.
C2000