Cutting Feed - Ipr; Cutting Feed - Based On Feed Per Tooth And # Of Teeth - Calculated Industries 4088 User Manual

CUTTING FEED – Ipr
Cutting Feed is the distance the cutting tool or workpiece
advances during one revolution of the spindle, typically
measured in Inches per Revolution (IPR). You can calculate
Cutting Feed given values for the Feed per Tooth or Chip Load
(IPT) and Number of Teeth. If these values are unknown, you
can calculate Cutting Feed with Feed Rate (IPM) and RPM
(Spindle Speed).
cutting feed – Based on Feed per Tooth and # of Teeth
Calculate the Cutting Feed (IPR) with a Feed per Tooth (IPT)
of 0.005" and 4 Teeth:
1. Enter the Feed per Tooth:
45 n
T
T
T
T
T
T
g* all cleareD
anGle
(Ө)
feeD/tooth
aDJ.
feeD/MinUte
nUMber of teeth
rpM
rct. aDJ. factor
leaD anGle aDJ.
User's Guide — 31
45.°
0.024 inch
24.508 inch
2.
516.
1.400
1.414
0.
(cont'd)