Feed Rate; Feed Rate - Based On Cutting Feed And Rpm (For Turning); Feed Rate - Based On Cutting Feed And Rpm (For Drilling) - Calculated Industries MACHINIST CALC PRO User Manual

Table of Contents

Advertisement

FEED RATE

Feed Rate is the speed of the cutting tool's movement relative
to the workpiece as the tool makes a cut. You can calculate
Feed Rate given values for Cutting Feed and RPM (Spindle
Speed). If you don't know the Cutting Feed, you can calculate
Feed Rate with Feed per Tooth (Chip Load), Number of Teeth
and RPM.
feed Rate – based on cutting Feed and rPM (for Turning)
Calculate the Feed Rate if you are turning a 25 mm steel
round stock down with a Cutting Feed of 0.80 millimeters
per revolution (mm/rev) and a rotational speed of 900 RPM
(Spindle Speed):
KeysTRoKe
OO
1. Enter the Cutting Feed:
. 8c
2. Enter the RPM:
9 00 R
3. Calculate the Feed Rate:
f
f
f
feed Rate – based on cutting Feed and rPM (for Drilling)
Calculate the Feed Rate for a drilling operation that is using a
recommended Cutting Feed of 0.10 millimeters per revolution
at 800 RPM (Spindle Speed):
KeysTRoKe
OO
$
CUT
0.8
RPM
feeD 720.0000
RPM
$
CUT
0.8
U
'
G
ser
s
DIsPlay
0.
MM/ReV
$
900.
MM/MIn
$
900.
MM/ReV
DIsPlay
0.
(cont'd)
— 23
Uide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MACHINIST CALC PRO and is the answer not in the manual?

This manual is also suitable for:

4089

Table of Contents