System Integration; System Integration Instructions; Function Check - Siemens SITRANS F Operating Instructions Manual

System integration

5.1

System integration instructions

This chapter provides information on how to integrate the flowmeter in a Modbus RTU
automation and control system.
The chapter shows the necessary steps in order to put the system into operation. After
finishing the steps, the system is ready to go into normal operation in the Modbus RTU
automation control system.
Note
Storage location
All Modbus settings of the transmitter are stored in the transmitter in a non-volatile memory.
Device name and address
The transmitter is shipped with a default device name and serial number.
All devices are shipped with a temporary address that allows the host to automatically
commission the transmitter. The network address is the current device address used by the
fieldbus.
Note
It is recommended NOT to use the default address in a multi-slave network. It is of great
importance to ensure that no devices have the same address. Otherwise an abnormal
behaviour of the whole serial bus can occur, the master being unable to communicate with
all present slaves on the bus.
5.2

Function check

Before proceeding further, make sure that installation and connection have been performed
successfully.
● See Hardware Installation (Page 11) for installation verification.
● See Connecting (Page 13) for connection verification.
When the function check has been successfully carried out, the device can be switched on.
MAG 8000 Modbus RTU
Operating Instructions, 04/2016, A5E03409989-AB
5
17