Send Instruction - Mitsubishi MELSEC-L series Programming Manual

5.4.5

SEND instruction

J(P)_SEND
G(P)_SEND
Structured ladder
J_SEND G_SEND
EN ENO EN
Jn* d Un*
s1 s1
s2 s2
Input argument EN: Executing condition
Jn*: Network number of the host station (1 to 239, 254)
254: Network specified in
access
Un*: Start I/O number of the module
(00 to FE: Higher two digits when expressing the I/O number in
three digits)
s1: Variable that stores control data
s2: Start number of the host station's device that stores write data :ANY16
Output argument ENO:
Execution result
d: Variable that turns ON upon completion of the instruction
d[1] also turns ON at the time of error completion.
Setting
data
Function
This instruction sends data to another station.
5.4 CC-Link IE Controller Network, MELSECNET/H, and Ethernet Instruction
ST
ENO:=
ENO J_SEND
ENO:=
G_SEND
d
"
Valid module during other station
"
Internal device
R, ZR
*1
Bit Word
−
s1
−
s2
d
*1: Local devices and file registers per program cannot be used as setting data.
J_SEND, G_SEND
P: Executing condition
instructions.
J_SEND
G_SEND
(EN, Jn*, s1, s2, d);
(EN, Un*, s1, s2, d);
:Bit
:ANY16
:ANY16
:Array of ANY16 [0..17]
:Bit
:Array of bit [0..1]
J \
U
Bit Word
5.4.5 SEND instruction
J_SEND, G_SEND
CC IE NET/H E71
:
indicates any of the following
JP_SEND
GP_SEND
Zn Constant Others
\G
−
−
−
5-157
5