Mitsubishi MELSEC-L series Programming Manual page 185

Device Item
Arrival monitoring time
[8]
s1
Read data length
[9]
s1
–
[10]
s1
*3
Clock set flag
[11]
s1
[12]
s1
Clock data at the time of
to
*4
error completion
[15]
s1
Error-detected network No.
[16]
s1
*3
[17] Error-detected station No.
s1
*1 :
*2 :
*3 :
5.4 CC-Link IE Controller Network, MELSECNET/H, and Ethernet Instruction
Specify the monitoring time required for the instruction completion.
If the instruction is not completed within this time, it is resent by the
number of times specified in
Description
0 to TCP retransmission
timer value: Monitoring is
performed by the TCP
retransmission timer value.
Ethernet
(TCP retransmission timer
value + 1) to 16383:
Monitoring time (unit:
second)
MELSECNET/H
0: 10 seconds
CC-Link IE
1 to 32767: 1 to 32767
controller network seconds
Specify the number of read data.
Description
Ethernet
MELSECNET/H
Reading from the QCPU
CC-Link IE
controller network
Reserved
Valid/invalid status of the data in the area starting from
0: Invalid
1: Valid
Clock data at the time of error completion are stored in BCD format.
b15 to
Month (01 to 12
[12] H H
s1
Hour (00 to 23 )
s1 [13] H H
[14] Second (00 to 59
H H
s1
[15] Year (00 to 99 ) First two digits
H H
s1
Network number of the station where an error was detected is stored.
(However, when an error was detected at the host station, the network
number is not stored.)
1 to 239: Network number
Number of the station where an error was detected is stored.
(However, when an error was detected at the host station, the network
number is not stored.)
*3
Ethernet
1 to 64
MELSECNET/H
CC-Link IE controller
1 to 120
network
Specification is possible when the
D or later.
(Specification is not possible for other modules. An access is always made to the target station CPU.)
Specification is possible when the versions of the QCPU and the network module on the
the target station are as indicated below.
(Specification is not possible for other modules. An access is always made to the target station CPU.)
• Network module: The first five digits of the serial number are '06092' or higher.
• QCPU: The first five digits of the serial number are '06092' or higher.
Data are stored only when 1 is set in bit 7 of Error completion type (
Setting data
[7].
s1
Setting value
0 to 16383
0 to 32767
Setting value
1 to 960
(word)
[12] is stored.
s1
b8 b7 to b0
)
Year (00 to 99 ) Last two digits
H H
Day (01 to 31 )
H H
) Minute (00 to 59 )
H H
Day of week (00 to 06 )
H H
00 (Sun.) to 06 (Sat.)
H H
host station is a network module or Ethernet module of function version
5.4.1 READ instruction
J_READ, G_READ
Setting range
Setting side
0 to 32767 User
1 to 960 User
User
–
System
–
System
–
System
–
System
–
station and
host
[0]).
s1
5-139
*1
5