Table of Contents
Advertisement
Measurement data display
<Waveform scrolling direction: Vertical >
Data capture bar
During data capture, indicates capturing time and the remaining capacity of the capture media.
(When the remaining capacity runs short, the display changes into orange.)
During replay, indicates information about the displayed position.
Digital display
Displays the input value of each channel.
Use the SPAN/TRACE/POSITION key to check the setting value of each channel.
Pen display
Displays the position of each channel signal with the pen.
In addition, displays the trigger position and the alarm range.
Trigger level display
Displays the trigger level position and direction.
<H>
* Displays the trigger level also in horizontal scrolling.
Alarm range display
Displays the alarm position and range.
An alarm is generated when a signal enters the green area shown in the following figure.
(When an alarm is generated, the display changes into red.)
* Displays the alarm range also in horizontal scrolling.
Waveform display (Present)
Displays measurement signals as waveforms in real time.
Compressed waveform display (Past)
Displays measurement signals in compressed format.
The compression rate can be set using the menu.
Refer to the User's Manual in the supplied CD-ROM for more information on the setting.
Sampling interval display
Displays the current sampling interval.
File name display
Displays the name of the file used to capture data.
(Displayed only while data is being captured.)
Data capture bar
Digital display
Pen display
Waveform display (Present)
Compressed waveform display (Past)
Sampling interval display
File name display
<L>
<Win In>
<Waveform scrolling direction: Horizontal >
<Win Out>
32
Advertisement
Table of Contents
