Presenter Tab - Configuration; Configuration - Modes - Microcom 485TC Operator's Manual

Direct thermal printer

Hide thumbs Also See for 485TC:

Table of Contents

Getting Started

3.16.12.1

Presenter tab - Configuration

The fields listed under the Configuration section control the Presenter operation on printer

model that are compatible with the presenter.

3.16.12.2

This is used to select the mode of the presenter. The valid modes are enabled,

passthrough, and disabled. When selecting Enabled, the printer with presenter would

present the media using the other fields for operation while selecting Passthrough mode will

simply cause the presenter to run while the printer is printing.

3.16.12.2.1 Configuration - Take-Label/Retract Timeout (secs)

This field controls the time that the presenter will present the paper before retracting into the

waste bin.

3.16.12.2.2 Configuration - Maximum Present Distance (inch)

This is the maximum size that the printer will present when using the enabled mode. This

value is in inches.

3-28

485TC Operator's Manual - 880058-0100

Chapter 3

Table of Contents

Table of Contents

Do you have a question about the 485TC and is the answer not in the manual?