13.3
Removing the rear wheel
Main work
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change the front wheel bearing.
–
Clean and grease shaft seal rings
of the spacers.
Long-life grease (
–
Insert the spacers.
H00935-10
–
Clean and grease the wheel spindle.
Long-life grease (
–
Position the front wheel.
The brake linings are correctly positioned.
–
Insert the wheel spindle.
–
Mount and tighten screw
Guideline
Screw, front wheel
A00152-11
spindle
–
Operate the hand brake lever several times until the brake
linings are seated correctly against the brake disc.
–
Remove the motorcycle from the lift stand. (
–
Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
Tighten screws
Guideline
Screw, fork stub
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
13 WHEELS, TIRES
1
and contact surface
p. 123)
p. 123)
2
.
M20x1.5
35 Nm (25.8 lbf ft)
3
.
M8
15 Nm (11.1 lbf ft)
p. 45)
A
p. 45)
p. 45)
85