Removing The Main Silencer; Installing The Main Silencer; Changing The Glass Fiber Yarn Filling Of The Main Silencer - Husqvarna TC 85 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.27
11.28
11.29
58

Removing the main silencer

Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down before performing any work on the vehicle.
K00982-11

Installing the main silencer

K00982-10

Changing the glass fiber yarn filling of the main silencer

Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down before performing any work on the vehicle.
Info
Over time, the fibers of the glass fiber yarn escape and the damper "burns" out.
Not only is the noise level higher, the performance characteristic changes.
Finishing work
–
Install the air filter. (
–
Install the air filter box cover. (
Preparatory work
–
Remove the right side cover. (
Main work
–
1
Remove screw .
–
Pull off the main silencer from the manifold at rubber
2
sleeve .
Main work
–
Mount the main silencer with rubber sleeve
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
Finishing work
–
Install the right side cover. (
Preparatory work
–
Remove the right side cover. (
–
Remove the main silencer. (
p. 57)
p. 56)
p. 59)
1
.
2
.
M6 10 Nm (7.4 lbf ft)
p. 60)
p. 59)
p. 58)