Table of Contents
Advertisement
10 TUNING THE CHASSIS
10.17
44
Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged or bent.
C00249-10
–
1
Remove screws
. Take off the handlebar clamps. Remove
the handlebar and lay it to one side.
Info
Cover the components to protect them against dam-
age.
Do not kink the cables and lines.
–
2
Remove screws
. Remove the handlebar support.
–
Place the handlebar support in the required position. Mount
2
and tighten screws
.
Guideline
Screw, handle-
M10
bar support
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position the handlebar clamps. Mount screws
evenly.
Guideline
Screw, handlebar
clamp
Info
Make sure the gap widths are even.
40 Nm (29.5 lbf ft)
Loctite
1
and tighten
M8
20 Nm (14.8 lbf ft)
®
243™
Advertisement
Table of Contents
